Customer Reviews for VEVOR Compound Slide Milling Table, 4-7/10" x 4-3/10" Multifunction Milling Bench Drill, Adjustable X 120?mm Y 108 mm Axis Milling Machine Worktable, Compound Cross Slide Table for Bench Drill Stand

There is a little slop in the XY when it arrives, but tightening the shims and a teardown/rebuild fixes most of it. Unless you are doing heavy milling operations--BUY IT! I turned my milling table into the XY of a DIY Lathe. So long as the shims are tight, the cuts are clean! I'm incredibly impressed by the craftsmenship of this milling table. Definitely definitely worth the money!

I received mine and took it apart and cleaned all the shipping coatings. Applied some ways oil to all sliding surfaces and spindle oil to the threaded hand wheel screws, adjusted the gibs to tighten up play/backlash. Set on my drill press and made a quick test run on some Delrin block. I was very pleased and now can use my drill press for some basic milling on light materials which is exactly why I purchased it. Mission accomplished and I'd recommend it.BTW it is very heavy so you'll most likely need to brace your drill press table - depending on its sturdiness.

The dials are in mm. The x y travel is 66mmX116mm. Solid build. The only flaw is a lot of backlash in the lead screw.

The slides are basicly good but need a bit of work. I scraped the machining marks out and scrapped the slides in. Also removed the sharp edges and the slides are great now. The cast iron is a bit on the soft side but it will be ok. I will add that I am a machine tool fitter machinist by trade.D.P.

A little rough around the edges but easy enough to square up and a solid build.Best Buy for the buck from what I found.

The slides on the table needed a little adjustment to get them to track easier and reduce sideways movement, but all in all a well made piece of kit, very pleased with it